@laurieclayton4976
Thanks for the Info. got my new DS18B90 up and running in less than 20 minutes. Had to watch your video a lot you are very fast.
@Saratonnin
Thanks Dude, you made this super easy to understand. Been looking for a description like this all day.
@mincongliu6236
Short and super helpful. Thanks!
@alaninkarachi
Hi, I've been trying to get this to work for ages. Many many thanks.
@gabracal
Nice Vid! But I'm worried about the resistor leads touching the other pins. (0:37)
@Electromaniaworld
thanks . i also showed how to get data from ds18b20 using normal usb ttl adapter, without using any microcontroller. may be that might be of your interest.
@andrevc85
straight to the point and helpful. liked 3 times
@MN-be7sx
Please make video on, how to connect 10 (ten numbers) humidity and temperature sensors with Respberri Pi or Ardiuno. And important is these sensors having 150 meters lengthy cables. Please make detailed video thanks in advance.
@PyroChimp75
Great little tutorial, thanks!
@BGLENN-dp4tx
It is not very good electronics protocol to jumper the 4.7k resister across the top of the breakout board. Put the resistor to an empty breadboard hole and use an insulated wire. As can be seen in the video image @ 1:10, the resistor wire is dangerously close to shorting out D12 to both D11 and D10 - all together -- not to mention shorting A4 to Vcc on the other side of the board. If you must route a resistor in this way, strip a section of insulated wire and use the insulation over the wires of the resistor. These precautions will save hours of frustrating software troubleshooting on a board that has a couple of bad/zapped pins due to momentary misconnections/shorts.
@kevynkelso5949
Super helpful, Thanks!
@neilsumanth8013
Thanks a lot!!!!!! ...its really helpful
@bangagun11
tq for this vidio tutorial, go ahead
@dtn2529
The display of negative temperature is not treated.
@aboudisyrian
Please show us how we can display the temperature on seven segment
@mehmetkilic1555
Does the LCD have a connection scheme
@kyungjindaum
Hey super helpful video! So I am trying to use DS18B20 to create a breathing monitor. Where do you think is the best placement for the DS18B20 sensor to measure temperature change when breathing?
@farhanahnabilah8308
Is DS18B20 suitable to measure the temperature of soil?
@joelnenko5879
You can make an algorithm for the program please
@errolsternberg8185